I purchased the IT-100 board and then decided I wanted to expand it a bit further to include more zones.
Dsc Alarm System Keypad Code When TheyThe company who originally installed the alarm did not record the installers code when they installed it so I was up a creek as far as knowing the installer code.I decided to reprogram it myself and here are my notes for anyone attempting to program or even reprogram their own DSC alarm.NOTE: if you are buying a new DSC I would suggest getting the PK5500 keypads instead of the PK5501 keypads.![]() I have another system with PK5500 keypads and they are great. To do this you have to short the zone 1 pin (not the z1 common pin) with the PGM1 pin. Thus, you have to ground Z1 to PGM and power the system up for 10 seconds and then power it off, remove the jumper and then power it back on. This is the first DSC alarm I have programmed so I am always open for commentary on the process. You have to tell the DSC this or it will think all of the zones are in an alarm state. ![]() Thus well enter programming mode and enter 013 and hit 1 to enable option 1. Each zone will traditionally fit into either: Delay 1 (01), Delay 2 (02), Instant (03), Interior StayAway (05). Therefore, I had to tell it not to consider the alarm in trouble mode if the telephone system was having issues in the Third System Option. You have to partition the zones above eight be in the same partition as the other zones. I have 24 zones on my system provided by the 8 default zones on the PC1832 and the 16 additional zones from the two additional PC5108 expanders. The DSC factory resets with zones 9-X in partition 0 so they do not appear in partition 1 automatically. The IT-100 board was fun to mess with and was somewhat nostalgic.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |